Nacho Solutions

How to Prepare Walls for Painting

Ask any painter what makes a paint job last, and the answer is never the paint — it is the preparation. Paint sticks to what is underneath it, so a wall that is dirty, damaged or glossy will show through the most expensive paint you can buy. Here is the prep work that comes before the first coat. We are a general contractor serving Toronto, Mississauga, Oakville and Burlington, with 11 years of experience, licensed & insured with $2M liability. Nacho and Milu organize and coordinate every project, and all trades are done by licensed specialists.

Clear and Protect the Room

Everything starts with the room. Furniture is moved to the centre and covered, or out of the room entirely. Floors are protected with drop cloths, and the edges are taped where the floor meets the baseboard. Light fixtures, switch plates and outlet covers come off or are masked. It is slow work, and it is the work that protects everything you are not painting.

In a renovation, this step is easier: the room is already empty, the floors are protected as part of the build, and the painters work in a space that was planned for them. That is one of the quiet advantages of painting as part of a larger project.

Clean the Walls

Paint does not bond to grease, dust or smoke residue. Kitchen walls near the stove, bathroom walls near the shower, and any wall that has been lived with for years should be washed before painting. A mild cleaner and a sponge are usually enough; the wall should be left to dry fully before anything else happens. Skipping this step is the most common reason paint peels in a kitchen or bathroom.

Fill, Patch and Sand

Every hole, crack and dent is filled before painting. Small holes take filler; larger damage takes a drywall patch, taped and coated. Once the filler is dry, it is sanded smooth — and the dust is wiped off, because paint over sanding dust does not stick. Run your hand over the wall when you think you are done: if you can feel a ridge or a dip, you will see it once the paint is on.

Glossy old paint should be sanded lightly too, just enough to give the new paint something to grip. A wall that is shiny and smooth is a wall the new coat will slide off.

Prime Where It Is Needed

Primer is not needed on every wall, but it is needed on every bare surface: new drywall, patched areas, filler, bare wood, and any stain that might bleed through. A stain-blocking primer is used over water marks and smoke stains, because ordinary paint will not hold them back. Primer also evens out the surface, so the top coats go on uniformly instead of flashing — looking patchy where the wall absorbed the paint differently.

One coat of primer on a repaired wall is the difference between a repair you cannot find and one you can see every time the light hits it.

Tape the Lines That Matter

Masking tape goes where two surfaces meet and the line has to be sharp: along the ceiling, along the trim, around windows and doors. The tape is pressed down firmly so paint cannot bleed underneath, and it is removed while the paint is still slightly wet, so the edge stays clean. Tape is not a substitute for a steady hand, but it is what makes a crisp line along the ceiling possible in a room that is not perfectly square — which is most rooms.

In our renovations, preparation is part of the painting work itself, done by licensed specialists and coordinated with the drywall work that comes before it and the trim work that comes after. Nothing is painted until the wall underneath is ready.

Message us on WhatsApp at (416) 706-3577 for a free painting quote

Tell us about your home — the rooms and the walls — and we will walk you through the six stages. Now booking January 2027.