Trim — baseboards, door frames, window casing, crown moulding — is painted more often than walls and judged more harshly. It is at eye level, it catches the light, and it is touched every day. The tool you paint it with decides what the finish looks like, and each method has a place. We are a general contractor serving Toronto, Mississauga, Oakville and Burlington, with 11 years of experience, licensed & insured with $2M liability. Nacho and Milu organize and coordinate every project, and all trades are done by licensed specialists.
A brush is the standard tool for trim, and for good reason. It gets into the corners, follows the profile of the moulding, and gives the painter control over exactly where the paint goes. A good brush, loaded properly and laid off in long, even strokes, leaves a smooth finish with no visible marks — but it takes a steady hand and unhurried work.
Brushwork shows when it is rushed: drips at the bottom edge, brush marks where the paint was overworked, a line where a wet edge was left to dry. The rule is to work in sections, keep a wet edge, and never go back over paint that has started to set.
A roller is fast on wide, flat trim — a broad baseboard or a flat door slab — and it leaves a light, even texture. But a roller cannot do detail: it will not get into the corners of a profile, it cannot cut a line against the wall, and on narrow trim it is clumsy. The usual approach is a combination: roller for the flat runs, brush for the edges, the corners and the detail.
A small foam roller is the usual choice for trim, because it leaves less texture than a fabric roller. Whatever the tool, the paint should be applied thinly and evenly — two thin coats always look better than one thick one.
Spraying gives the smoothest finish of all — no brush marks, no roller texture, just an even coat. It is how new doors and new trim are often finished in a workshop, and it is the best choice for a large run of identical trim, or for doors that have been removed and sprayed flat.
The trade-off is preparation. Everything that is not being painted must be masked — walls, floors, hardware, glass — and the room must be ventilated. Spraying in an occupied home is rarely practical, which is why it is usually done on new trim before installation, or on doors taken off their hinges. In a renovation, that is a decision for the design phase, when the order of work is planned.
No method saves a badly prepared surface. Trim is filled where it is dented, caulked where it meets the wall, sanded smooth, and primed where the wood is bare or the old paint is stained. Caulking the joint between the trim and the wall is what makes the line look crisp — but the caulk must be paintable, and it must be smoothed before it dries, or it will show as a ridge.
Old trim that has been painted many times needs more work: the layers are sanded back, the drips and rough edges are smoothed, and the surface is primed so the new paint bonds. Sometimes the honest answer is that the trim should be replaced rather than repainted — a decision made in the design phase, not halfway through the job.
Trim is usually painted in a satin or semi-gloss finish: hard-wearing, easy to wipe clean, and just reflective enough to make the profile stand out against a flat wall. The colour is usually white, chosen with the wall colour, and the same white runs through the whole home so the trim ties the rooms together.
In our renovations, trim is painted by licensed specialists as part of the finished room — filled, sanded, primed and painted, after the walls and before the final walkthrough. It is the frame of the room, and it is finished like one.
Message us on WhatsApp at (416) 706-3577 for a free painting quote
Tell us about your home — the rooms and the trim — and we will walk you through the six stages. Now booking January 2027.